Oldedays Classic Car Parts

New.  these fit 1955 Chevy Passenger cars.  do NOT come with screws.  EO53.

New. Fits 1955 Chevy Passenger Cars. These important bumpers, located on either side of the hood, help to keep the hood properly aligned and in place. #225

One Pair.  For use with the dashboard ashtray. One pair needed per ashtray.  2076.

New.  One each.  This is a reproduction of the original for 1955 and 1956 models; its an excellent functional replacement for the 1957. Dont worry about being detected, bumper is hidden from view and will not be noticed.  #818.

As old grommets age they shrink and leave excess play that you will hear every time you drive your car. Will work on any 1955-1956 Chevy passenger car model.  234.

New. Without these stops your seat just doesn't sit right! Please compare your part against the stops pictured above. Car seats are often swapped over the years; your seat may not be the correct one from your model year. #607

New. Danchuk #831. Door window flipper stops.

NEW, You are purchasing one PAIR. The rear axles up and down travel is limited by these rubber bumpers, and they, needless to say, take quite a beating. Periodic inspection and replacement is required for these important parts. #862

This bumper is for the rear sliding glass on Nomads as well as the rear seat latch on Nomads and Wagons. #814

Will work on any 1955-1957 classic Chevy model with Original front Motor Mounts.  Set of 8 cushions replaces both sides. EO433.

New. These rubber seat stops are mounted to the cars bodywork in the rear seat well of the Nomad and station wagon. They support the rear seat back cushion when the seat is folded down. #1495.

All Nomad tailgates require four bumpers. Some wagons and Sedan Deliveries also utilize these same bumpers. Check your tailgate for worn or missing bumpers, which are the contact point for the closed tailgate. #1822

One Pair of Lower Trunk Lid Rubber bumpers.  Will work on any 1955-1957 sedan, hardtop or convertible classic Chevy model.  RR-23-169.

This kit will do both the upper and lower bumpers in the trunk area of your classic.  Will work on any 1955-1957 sedan, hardtop or convertible classic Chevy model.  16277.

New.  This turn signal bushing and rubber pads are installed into the #904, turn signal mechanism and protect the turn signal pawl from undue wear. #1741

NEW, You are purchasing one each. The rear axles up and down travel is limited by these rubber bumpers, and they, needless to say, take quite a beating. Periodic inspection and replacement is required for these important parts. #861

Take the clunk out of your windows with these bottoming stops!  These are located inside the door at the bottom and support the window when it is rolled down.  Will work on any 1955-1957 classic Chevy model. One Pair.  #184.

New.  Even with new weatherstrip, the door needs these bumpers to close securely and keep from rattling. This bumper also serves as the liftgate on body rubber bumper for 55-56-57 station wagons. Made in the USA. each.  #806.

New. Fits 1956 AND 1957 Chevy Passenger Cars. These important bumpers, located on either side of the hood, help to keep the hood properly aligned and in place.  226, EO49.

New.  Rubber bumper set for 1957 Chevy passenger car gas/fuel door.  #808.