Oldedays Classic Car Parts

A pair of side motor mount Brackets only for 1949 to 1954 Chevy passenger cars to mount V-8 engines. SBC or BBC. Will not work with stock steering. you must change to a mustang II front end.

A pair of side motor mount Brackets for 1949 to 1954 Chevy passenger cars to mount V-8 engines. SBC or BBC. Will not work with stock steering. you must change to a mustang II front end. Comes with Hardware and motor rubber mounts.

Made in USA. Use this to put a TH 350/400/700R4 Transmission in your 1955-1956 265 V-8 and to continue to use the stock starter. Requires 168 tooth flex plate.  Use this plate in 1957 models with broken starter mount holes or pads.

New. Set includes rubbers, washers, shaft and nuts; all the parts you need to replace ONE side. NOTE: TWO sets are needed per car. For Small Block V-8 and 6 Cylinder Engines, Original Front Mount positions only. 198.

This Bracket set is for LS1 to Factory small block chevy 1955, 1956 or 1957 passenger car.

Stud set for 1955-1957 Chevy Passenger Cars.  comes with studs, washers, cushion plates and nuts.  will do both sides.  use with our item number SGR0194.  EO432.

New. Made in USA. You can bolt it in or weld the side brackets to your frame. Very nice unit. Comes with hardware and instructions.

New. This one is for mounting your engine 3/4" forward, and a TWO piece frame (Weld seam on top of frame). Made in the USA. Comes with hardware to bolt in or you can weld them in.

New. This one is for mounting your engine 3/4" forward, and a ONE piece frame (NO Weld seam on top of frame). Made in the USA. Comes with hardware to bolt in or you can weld them in.

New. This one is for the stock location and for a TWO piece (Welded - with seam) frame. Made in the USA. Comes with hardware to bolt in or you can weld them in. These fit Chevy Small Blocks (can use either stock position or 3/4 forward).

New. This one is for the stock location and for a ONE piece (seamless) frame. Made in the USA. Comes with hardware to bolt in or you can weld them in. These fit Chevy Small Blocks (can use either stock position or 3/4 forward).

New. These are for our 1955 to 1957 Chevy Side Motor Mount Brackets. you are ordering ONE PAIR.

New. These are for our 1955 to 1957 Chevy Side Motor Mount Brackets. you are ordering ONE PAIR.  This kit comes with Mounting hardware.

New. These mounts are the ones you need to make the new engine fit nice and the transmission needs for the extra support. Made in the USA. With bolts and instructions.  Fit all Automatic Turbo Transmissions, NOT Manual.